So – in the past week, my order arrived. Have been thinking of ordering a couple of units that everyone talks about… Really don’t know why it took so long time, but now I have four E...
As written earlier, I managed to write my own process to communicate with the PowerMax alarm. This actually works really well, but I have not taken the time to make this process communicating two ways...
As i wrote in previous post, I have temporarily ditched my own server process for bridging MySensors to MQTT and then integrate it in openHAB, with a setup that means that openHAB is used as the contr...
There has not been very much action in the home automation or prototyping areas since last post. However, I managed to update the project to MySensors 1.4 protocol (yes, I know there is a 1.5 version ...
As earlier posts described, i’m fascinated over the project ”MySensors”. However, I will not replace my setup of the openHAB server and my MQTT-implementation (using RabbitMQ). This ...
Hi again – no doubt it was some time since my last post here. Has the project been on hold? No, not at all. A couple of weeks ago – I took the step and ordered some things for a sensor net...
Yesterday, I realized that I actually had one Dallas DS18B20+ OneWire temp sensor laying around and not being used. That piece of electronics together with an almost unused Raspberry Pi would actually...
Hi! So – the first step has now been completed. The Arduino Nano is now actually getting it’s data all the way to the MQTT bus. Right now, it’s in a pretty ”rough”/testin...
And so the saga begins. My first Arduino Nano with some sensors just arrivedthe goal is to somehow mqttify these prototypes and use them with openHAB. I will post my progress – good as bad 🙂...
Introduction One room that is actually fully automated now is our main bathroom. From a equipment point of view, there are two Fibaro dimmers (FGD211) and one Aeon 4in1 sensor (temp, humid, light, mot...